VARSEO VarseoSmile Crown plus, B1, 250g - #41120 3D Resin
Earn up to 280 rewards points with this product!
Join today and start earning rewards points and unlock exclusive savings with US Dental Depot's Customer Loyalty Rewards Program
Description
VarseoSMILE Crown PLUS
The tooth-colored ceramic filled Hybrid material for 3D printing of permanent single crowns, inlays, onlays and veneers
Advantages for the laboratory
- Specially for the resin developed printing and processing parameters ensure smooth production sequences with reproducible results at any time
- High dimensional stability and strength of the printed objects due to high values of flexural strength and flexural modulus – therefore precise fit
- Minimized resin sedimentation for easy handling, no mixing or shaking necessary with regular use
- Easy to grind and polish by using standard tools
- Seven shades according to the proven VITA* classical shades:
A1, A2, A3, B1, B3, C2, D3 - Satisfies all the requirements for a Class IIa** medical device
Advantages for the patient
- Excellent aesthetics thanks to a balanced ratio of opacity and translucency
- Low tendency to age and discolor thanks to very low water absorption
- Low plaque accumilation due to smooth surface
- High comfort thanks to low cold and heat sensitivity
- Antagonist-friendly material with mechanical buffering effect – ideal for implant-supported crowns
- Minimized formation of secondary caries thanks to a high adhesive bond with luting composites
- High biocompatibility due to very low water solubility – therefore not cytotoxic, not genotoxic, not toxic, not irritating and not sensitizing
Individualization with stains
The individualization of the post-cured objects is possible with composite stains and is the responsibility of the user. Follow manufacturer‘s instructions.
Note for practitioners
VarseoSMILE Crown PLUS can be attached using self-adhesive cements (e. g. RelyX Unicem*, 3M Espe*) or composite cement with a primer (e. g. Variolink Esthetic DC* and Monobond PLUS*, Ivoclar Vivadent*). Observe the instructions for use of the luting agent.
Light-curing
The light polymerization can be achieved with the BEGO Otoflash (two xenon stroboscopic lamps, flash frequency 10 Hz, light spectrum 300 – 700 nm) or with the HiLite Power*, Fa. Heraeus Kulzer* (one xenon stroboscope lamp, flash frequency 20 Hz, light spectrum 390 – 540 nm).
| Light-curing device | Light-curing | Comments |
|---|---|---|
| BEGO Otoflash (with protective gas) | 2 × 1,500 flashes | Turn object between the exposure cycles |
| HiLite Power | 2 × 90 seconds |
| Color | A1, A2, A3, B1, B3, C2, D3 |
| Density | approx. 1.4 – 1.5 g/cm³ |
| Layer thickness | 50 ?m |
| Viscosity | 2,500 – 6,000 MPa*s |
| Flexural strength | 116 MPa |
| Flexural modulus | 4,090 MPa |
| Water solubility | 0.23 µg/mm³ |
| Water sorption | 3.6 µg/mm³ |
| Wavelength | 405 nm |