Heads up! 📦 No shipments will be going out until Thursday, the 26th.
We'll be back to our regular shipping schedule then. Thanks for your understanding!
The new LC-3DPrint Box allows you to post-cure NextDent 3D materials. Post-CURING is required in order to obtain the final material properties. After the Printing process, the printed material is not yet fully cured and should be treated. First, the material needs to be cleaned in an alcohol bath followed by the post-CURING cycle. Post-CURING is an UV light treatment to ensure that NextDent materials obtain full polymer conversion, through this the residual monomer is reduced to a minimum and the highest mechanical properties are obtained. This procedure is a necessary step to produce a biocompatible end-product. Always follow the instructions for use relevant to the corresponding material.
➤ High load capacity (LxB 26 cm , H19,5 cm)
➤ Full light spectrum (300-550 nm)
➤ Short polymerization times
➤ Controlled temperature for optimal CURING
➤ Noiseless
➤ Objects are illuminated from all sides
➤ New post-process method (without additional nitrogen)